Kentix MultiSensor-RACK Manual de Serviço descarregar pdf (Página 30)

System

System information

Shows the Firmware version number of the MultiSensor-LAN.

The actual firmware can be found on the Kentix Website in the section „Software & manuals“.

Test features

Test your E-Mail and SNMP settings via the two Buttons. The sending of E-Mails or traps is recorded in the

logbook.

Backup configuration

For backup-purposes the actual configuration of the MultiSensor can be downloaded here.

Restore configuration

Loads a previously created backup into the device and restarts it. The settings of the backup are directly

active afterwards.

Firmware-Update

Loads a firmware file (image.bin) into the MultiSensor and restarts it.

ATTENTION!

Pay attention to the relevant release notes of the downloaded update!

Restart

The MultiSensor-LAN can be restarted for testing or maintenance purposes. Note that the data recording is

suspended for the duration of the restart.

Switch alarm output 2

In the section Dashboard -> Control you have the possibility to switch the 2nd alarm output of the

MultiSensor-LAN. You can switch it for a specified period, by entering the time in seconds.

To switch the output permanently, enter a period of 0 seconds.

Page 30 ! ! ! ! (08-2014, subject to change) kentix.de

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 70 71

Sem comentários

Kentix MultiSensor-RACK Manual de Serviço Página 30