Kentix MultiSensor-RACK Manual de Serviço descarregar pdf (Página 17)

MIB for SNMP-Systems

For the AlarmManager-PRO a MIB (Management Information Base) is available, which describes the

information that can be requested or modified by a SNMP-System (z.B. PRTG, OpManager or WhatsUp

Gold). The single values in it are identified and requested via the OID (Object Identifier). Every value has his

own specific OID.

The following list shows the structure of the AlarmManager-MIB and gives an overview of the values that can

be requested:

๏

state

alarm1

alarm2

...

๏

multisensors

•

multisensor01

sensorname01

temperature01

humidity01

dewpoint01

co01

motion01

digitalin101

digitalin201

digitalout201

comError01

•

...

•

multisensor100

๏

ext-module

•

modul01port01

- portname

- portstate

•

...

•

modul06port16

๏

server-monitoring

•

server01

- servername01

- ...

- serverstate01

•

...

•

server20

๏

alarm-zones

•

alarmzone01

- alarmzonename01

- alarmzonestate01

- alarmzonealarm101

•

...

•

alarmzone30

Examples for the OID:

AlarmManager OID:! .1.3.6.1.4.1.37954.1

Query branch „state“:! .1.3.6.1.4.1.37954.1.1

Object „alarm1“:! ! .1.3.6.1.4.1.37954.1.1.4.0 - shows the actual state for alarm 1 (armed-active)

Query branch multisensors: .1.3.6.1.4.1.37954.1.2

Lower branch multisensor01: .1.3.6.1.4.1.37954.1.2.1

Objekt „temperature01“:! .1.3.6.1.4.1.37954.1.2.1.2.0 - shows actual temperature value of the 1st MultiSensor

Page 17 ! ! ! ! (08-2014, subject to change) kentix.de

state - System state:

Query branch of the AlarmManagers general system state.

Delivers the actual state as shown in the Web-Interface or

the Dashboard of the ControlCenter (e.g. Arm/Disarm,

Alarm1 (Armed-Active), Alarm2 (Always-Active), Fire, Server

state,...).

multisensors - MultiSensors RF/LAN:

Query branch for the values of all connected MultiSensors

(the branch shows all 100 maximum possible Sensors).

All values are displayed as integers, whereas temperature

and dew point are increased by a factor of 10, to consider

one more decimal place. This has to be taken into

consideration in the requesting SNMP-System.

ext-module - Module for external alarms:

Query branch for the In- and Outputs of the external modules

KIO7052/3.

Shows the configured name and the actual alarm state for

every In- and Output respectively at Outputs the switched

state.

server-monitoring - State of the monitored Servers

Query branch of the configured servers to be monitored.

Shows the configured name, IP-address and port of the

service to be monitored, the response time in milliseconds

and the alarm state (0-OK, 1-not reachable) for every server.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 70 71

Comentários a estes Manuais

Sem comentários

Kentix MultiSensor-RACK Manual de Serviço Página 17

Comentários a estes Manuais