Kentix KSS-BASIC-2-B Manual de Serviço descarregar pdf (Página 56)



8.6. Kentix Alarm sirene (KFLASH1)

The Kentix Alarm sirene can be used for an acoustical and optical signalization in case of an alarm.#

It is suitable for an indoor and outdoor installation (protection class IP65).

The Alarm sirene is equipped with a 10 meter patch cable and a RJ45-connector and can be directly

connected to the system jacks of an AlarmManager or to all MultiSensor-RF/-LAN/-LAN-RF using an

additional adapter (RJ45-T-Adapter). The required adapters are included with the Alarm sirene.

Figure 1: Alarm sirene at AlarmManager

Simply plug in the Alarm sirene into one of the system jacks.

Power supply and alarm signalization is done via the AlarmManager.

Figure 2: Alarm sirene at MultiSensor

Plug in the Alarm sirene into the RJ45 T-Adapter and connect the MultiSensor to the socket next to it using a

patch cable. The power supply is done via a Power-Adapter (KIO2), which is connected to the opposite side

of the T-Adapter.

When also the alarm input of the connected MultiSensor shall be used (e.g. by connecting a leakage

sensor), a KIO2 Power-Adapter can be used instead of the KIO1. In this case all connection cables have to

be patch cables.

Page  (04-2015, subject to change) kentix.com56

AlarmManager-BASIC/PRO

KENTIX System jack

Alarm sirene

MultiSensor-RF/-LAN/-LAN-RF/-RACK

KENTIX System jack

Alarm sirene

KIO1 or KIO2#

Power-Adapter

RJ45 T-Adapter

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 75 76

Sem comentários

Kentix KSS-BASIC-2-B Manual de Serviço Página 56