Kentix KSS-BASIC-2-B Manual de Serviço descarregar pdf (Página 14)



4.9. SMS commands for remote control of AlarmManager

The AlarmManager reports not only all the alarms via SMS, it can be also remotely controlled via simple

SMS commands from a mobile phone. This brings the big advantage of having the central alarm system in

your pocket and remotely setting the system to the desired states.

The AlarmManager can be armed or disarmed and alarms can be acknowledged remotely. So you can

decide if it is necessary to intervene on the ground at any time by using the SMS information and status

inquiry.

Important notes for remote control of the AlarmManagers via SMS

•

Upper- and lower-case can be used.

•

Between „Operator-PIN“ and „COMMAND“ is always a space.

•

The „Operator-PIN“ can have 4-8 alphanumerical characters. Setup the PIN with the ControlCenter.

•

The AlarmManager is confirming each command SMS with an SMS back to the sender.

•

Command SMS with the wrong phone number or password will not be confirmed for security reasons.

SMS control commands

Example: Arm-disarming of the AlarmManager via SMS command

SMS command

Description

Example

Confirmation

{PIN} ON

Arming of the AlarmManagers. All zones will be

armed..

1234 on

OK! ARM All Zones

{PIN} ON{ZONE}

Arming of the selected zone.

1234 on1

OK! ARM ZONE 1

{PIN} OFF

Disarming of all zones.

1234 off

OK! DISARM All Zones

{PIN} QUIT

Acknowledge of all pending alarms. The alarm

repetition is terminated.

The AlarmManager can be set to arm state again.

1234 quit

OK! ALARM QUIT

{PIN} STATE

The AlarmManager sends the actual system

state.

1234 state

OK! ARMED/DISARMED/

ALARM

{PIN} MSTATE1-n

The AlarmManager sends the actual system state

and values of a MultiSensor.

Enter the number of the MultiSensor (1-100)

directly after the command „MSTATE“."

The response contains the name of the

MultiSensor.

1234 mstate1

OK! SENSORNAME:

TEMP=20C

REL-HUM=25%

DEW-POINT=3C

MOTION=15%

EXT-IN=0

SABOTAGE=0

POWER=OK

Page  (04-2015, subject to change) kentix.com14

OK! ARM ZONE 123

1234 on

SMS command

SMS answer

NOTE!

When a sensor sends an alarm, the SMS contains the number of the sensor to send a mstate request.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

Comentários a estes Manuais

Sem comentários

Kentix KSS-BASIC-2-B Manual de Serviço Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - alarme Kentix KSS-BASIC-2-B